FlowerPot Glass Bowls


Here are the main design criteria

1) Outside Diameter  "OD" must be a close fit. This is the area that the machined Flowerpot head interfaces with and should be a close fit as possible without sticking.

2) Depth of Glass screen. In order to maintain consistency among FP customers we will strive to maintain 1/2" to the top of the screen. The glass screen should be able to handle fine grind needed for optimal vaporization. 

3) Use only 14 & 18mm ground joints 

Please do not hesitate to contact us with any questions! email: support@cannabishardware.com


There is a drawing for the inspection gage below


Older Post Newer Post

Leave a comment

Please note, comments must be approved before they are published