Flowerpot F16 "Injector" Head Assembly (7051)
Safety Instructions:
DO NOT use product for burn offs
DO NOT use above 700 degrees
DO NOT leave unattended
ALWAYS use on hard, flat, level surface.
WARNING! Must use more rubies than you may think. The level of the balls must exceed the brim in order for the threaded cap to put downward pressure on the balls and hence on the removable machined screen. Too few rubies could cause the screen to spin on an axis and spillage may occur.
- About 180 3mm Rubies until full.
- About 68 4mm Rubies until full.
- Coil NOT Included
*Rev A started shipping out on 6/7/23. All orders that had the original f16 were replaced with this Rev A. Rev A addresses seating issues.
Continuing the evolution....
The new Flowerpot F16 head is created at a time where ball vapes require some refinement. This new flowerpot head packs a punch as the heat sink is improved by the addition of a solid titanium machined cap and a machined screen at the bottom which further improves the conduction and retention of heat throughout the device.
There are two barrel designs, the F16 barrel is an injector style "male" head which will sit inside the shovelhead bowl and any other injector style bowl. The exposed 20mm coil design allows us to keep the cost down while offering full functionality.
This design has taken the guesswork out of assembly and disassembly, so you can now switch between heads or disassemble for cleaning with ease.
The machined cap is a threaded cap with styled grip notches for ease of assembly and disassembly.
The TOMCAT option will turn your F16 body into a Dual Use head. This means that you will have an injector and a standard diffuser in one head. READ MORE ABOUT THE TOMCAT CONVERSION CAP HERE.
The titanium drop in screen is tumbled to remove burrs but tumbling also causes the change in its finish color.
It has been argued in the community that there is a difference in flavor between the mesh screens and the solid titanium machined screens. This is due to using it at lower temps. Lower temps = More flavor.
Among the available and compatible bowls for this device in our store are the Goo Roo Insulated Injector Bowl, The CH Pass Through Injector Bowl, Elev8 Injector Bowl and the Ed's TNT Dual Purpose Bowls.
- About 180 3mm Rubies until full.
- About 68 4mm Rubies until full.
Recommended starting temperature on this one is 560F (with 3mm Rubies)
The Flowerpot F16 Head includes:
- Flowerpot F16 Injector Barrel (3465)
- Drop in Machined Screen (3468)
- Machined Intake Cap (3467) OR Tomcat Conversion Cap (3477)
Options
- 3mm Rubies (9422-3MM)
- 4mm Rubies (9422-4MM)
- Assembly only (7051 or 7055)